|
|
|
本帖最後由 dogcatpig01 於 9-5-2012 02:04 PM 編輯
Part 3 新的頸部gimmick
As we both know, Hot Toys added an new type of neck joint in Mark IV and VI, and the joint can move 45 degrees, but the problem is around the neck, there are a ring type soft plastic armor to limit mobility. So it can not set up a pose like the following picture.
It is a design problem, or you can personally called it "CG Bug", so now we are trying to give the figure more mobility.
First at all, cut the ring armor into this shape.
Second, at the body, there are a hole, glue the cut off part back in it.
Finally, it will become a new neck gimmick, when the head moves forward or backward, the armor behind the head will open and give space. After it turns back to 0 degree, you can "close" the armor. Like this:
And here are some pictures took after the work.
Part 1 腿
The reason for Iron Man become "Soft Leg" has the same problem.
Inside the knee, there are two spindles, and they are not stable and easy to break.
The solution is easy. Use a "Krazy Glue" to glue the broken spindle back to another side.
And Well.... it works now.
Part 2 出掌?
As a Ching wrote in his post before, original Hot Toys Iron Man is hard to open hand to 45 degrees, but it just need a little work to fix it.
http://www.toysdaily.com/discuz/thread-181279-1-3.html
First at all, cut off some plastic that close to the back of the hand, like this.
Second, the next question is not about 可動手腕甲, the problem is- there are no enough space between hand armor A and B, so we cut off a little bit plastic again.
And now, does it look a little bit better than before?
 |
|
發表於 8-5-2012 17:29:25
樓主
