Halfeye 死士團 : final form of Dai Sword

迷人超

較早前已更換了狀況較好的一隻，雖然其中一邊仍有像裂紋的線(紅圈)，不過亦算了。:67:


[ 本帖最後由 迷人超 於 14-2-2008 06:54 PM 編輯 ]

Monutal

Should be 夾口/分模線, if it's 裂紋... they will not last a minute. Remember they are resin cast... 裂紋 will kill it quick.

These toys are hand made so the quaility are not always the best hehehe...

Tachikoma

原帖由 迷人超 於 14-2-2008 06:51 PM 發表
較早前已更換了狀況較好的一隻，雖然其中一邊仍有像裂紋的線(紅圈)，不過亦算了。:67:

見裂紋的一邊從内部也見　没裂紋那邊内部也沒見有　但仔細看還是能見類似分模的線　上部如你所見　我相信是成形問題　並非件有問題　

迷人超

原帖由 Tachikoma 於 14-2-2008 08:49 PM 發表

見裂紋的一邊從内部也見　没裂紋那邊内部也沒見有　但仔細看還是能見類似分模的線　上部如你所見　我相信是成形問題　並非件有問題　
http://i258.photobucket.com/albums/hh242/TACHIKOMA1974 ...

對啊！就是連內部也有才覺得有問題。
其實小弟有一個監賞珠寶用的10倍放大鏡，一睇之下，疑似"裂紋"更像曾經斷過再用萬能膠黐返...
容許小弟胡亂推測：
合神、犀牛或戰車形態本來並無問題，但當由犀牛變形機械人形態時，需要拉開腳部，而該位有先天性的問題，因原模造得太貼，而當組裝技工每組好一隻後，由於此乃昂貴玩具，必需測試能否順利變形，但當技工測試時，就發生上面部件"迫裂"下面部件情形發生(如下圖)，於是唯有用萬能膠修補(某些強力萬能膠是無AA膠的"白化"現像，所以修補得好好)。如果是分模線，為甚麼有的兩邊都有裂紋，有的只有一邊有裂紋呢？

小弟覺得這是廠方的責任，與店鋪無關，而小弟亦已經更換了店中最好的一隻了(一邊正常一邊仍有疑似裂紋，但比之前一隻狀況好多了)，店鋪亦已盡了其責任，也就不和負責人繼續爭論，免得阻人做生意
。(在此特別呼籲，將犀牛形態變成機械人形態，務必加倍留神！)


[ 本帖最後由 迷人超 於 14-2-2008 10:21 PM 編輯 ]

cybaster

原帖由 迷人超 於 14-2-2008 22:18 發表

對啊！就是連內部也有才覺得有問題。
其實小弟有一個監賞珠寶用的10倍放大鏡，一睇之下，疑似"裂紋"更像曾經斷過再用萬能膠黐返...
容許小弟胡亂推測：
合神、犀牛或戰車形態本來並無問題，但當由犀牛變形機械人 ...

Oh..................

Wishing the coming cybaster will not have problem la~~~~~:o:o:o

garykctse

報告各位大大：小弟經由美國英雄協助下，已順利將重犯 Nova 拘束到本宅之監獄 :x

初步驗屍所見，犀牛腳底除有少許疑似「裂口」（在左腳；另外未開始正式玩，所以無法証實真偽）外，似無大問題（小 defect 在所難免）
GGGG 大人所提及之斷空劍花痕亦唔見有 :(

稍後再向各位大大報告 :shy:

[ 本帖最後由 garykctse 於 14-2-2008 11:01 PM 編輯 ]

Tachikoma

原帖由 garykctse 於 14-2-2008 11:00 PM 發表
報告各位大大：小弟經由美國英雄協助下，已順利將重犯 Nova 拘束到本宅之監獄 :x

初步驗屍所見，犀牛腳底除有少許疑似「裂口」（在左腳；另外未開始正式玩，所以無法証實真偽）外，似無大問題（小 defect 在所難 ...

記得影多D相:57:

genesicgaogaiga

原帖由 Tachikoma 於 14-2-2008 20:49 發表

見裂紋的一邊從内部也見　没裂紋那邊内部也沒見有　但仔細看還是能見類似分模的線　上部如你所見　我相信是成形問題　並非件有問題　
http://i258.photobucket.com/albums/hh242/TACHIKOMA1974 ...

I am sure that it is 成形問題.
Mine is having the same lines at the same sites.
Exactly the same.
I have used my magnifiying lamp for inspection. The line on the inner side is very straight, and not correlated  with the outer line. It is probably that the prototype was built by sticking this part woth AA glue. So after the molding, the connecting line is seen at the site. It is really impossible for crack line to occur at the same site with same pattern in all toys.

I tell you, the pattern is 100% same as you.

Don't worry and picky.
If you look carefully at your D. Nova with magnifying glass and measure the each part with ruler or protractor, you will notice more minor 成形問題.

e.g.
trunk tilted to one side.
nose tilted to right side.
not totally symmetrical
so paint is detached
some paint is not smooth enough.

etc.

For Godannar, the left arm is lower than right arm. All are the same, look at the one on web site.
I have to do a surgery to the right shoulder in order to balance both side.


If you have built resin cast in the past, you will find the similar problem.

Since I am having some degree of obssessive compulsive disorder, I am always picky to my toys. So I frequently do surgery to SHE toys. Unless you are as obssesive as me, just accept this problem for all resin cast built toys. Otherwise, you will always have to do surgery to your SHE toys.

kampferms18

原帖由 Tachikoma 於 14-2-2008 08:49 PM 發表

見裂紋的一邊從内部也見　没裂紋那邊内部也沒見有　但仔細看還是能見類似分模的線　上部如你所見　我相信是成形問題　並非件有問題　
http://i258.photobucket.com/albums/hh242/TACHIKOMA1974 ...

My Rhino also has similar "crack" line at the same area. I think it should be the problem of the mould. But that region is certainly a weak point during transformation. So must pay great attention.

genesicgaogaiga

combined pic of cybaster

kampferms18

I am very delighted and excited today. :43:  I finally manage to get these 3 boxes of brand new limited version of GFG, GoldyMarg and GunBuster with personal signature of 高島肇. Especially for GFG and GoldyMarg, they are my favourite and are difficult to find a new one now.







BTW, may I ask GGGG bigbig, my limited GFG does not have a pair of red and yellow fists for "Hell and Heaven". Is it normal? Many thanks!

迷人超

原帖由 kampferms18 於 15-2-2008 01:04 AM 發表
IBTW, may I ask GGGG bigbig, my limited GFG does not have a pair of red and yellow fists for "Hell and Heaven". Is it normal? Many thanks!

不如小弟代答，紅黃手掌只有"組立版GFG"先會有(即白件需要自己砌及上色，好似係限定50 sets)，通販限定版只跟Dividing Driver 及Gatling Driver。:78:
話時話大大o既簽名版點入手o架?Yahoo.jp拍賣場?
我好後悔之前無買Golden Hammer，希望會再販啦~!:no:

[ 本帖最後由 迷人超 於 15-2-2008 02:35 AM 編輯 ]

garykctse

原帖由 genesicgaogaiga 於 14/2/2008 23:55 發表

Since I am having some degree of obssessive compulsive disorder, I am always picky to my toys. So I frequently do surgery to SHE toys. Unless you are as obssesive as me, just accept this problem for all resin cast built toys. Otherwise, you will always have to do surgery to your SHE toys

:x :x :x

genesicgaogaiga

原帖由 kampferms18 於 15-2-2008 01:04 發表
I am very delighted and excited today. :43:  I finally manage to get these 3 boxes of brand new limited version of GFG, GoldyMarg and GunBuster with personal signature of 高島肇. Especially for GFG an ...

Limited version should have no red and yellow Hell and Heaven hands. They are the limited items from the white resin cast version.
By the way, congra.
Enjoy your GFG + GH!

[ 本帖最後由 genesicgaogaiga 於 15-2-2008 09:48 AM 編輯 ]

genesicgaogaiga

原帖由 garykctse 於 15-2-2008 06:35 發表


:x :x :x

Yes, I diagnosed myself to have some degree of OCD (obssessive compulsive disorder).
:34: