Death messenger is really dead! I got two and both have broken arms and legs!
Wow. CMS :53: :53: :53:
Ball joint can be fixed quite easily. In fact I already broke the ball joint on right shoulder shield of the Funny Devil. I just replaced it with Kotobukiya ball joint. alchemo bro, what do you use to fix the elbow and knee joints? I think CMS just have horrible joint design. The material feels like PVC which is hard but very brittle. The joints also have a lot of stress. This is probably why the joints will break even keeping in the box. :69:
I can upload a photo tonight on the fix. Among all those I bought, Shadow Flare is the worst.
Joints on these two Berserga are of different design. material seems the same though:(
So are you going to get these two Berserga? they look really good:he:
Ball joint can be fixed quite easily. In fact I already broke the ball ...
tman 發表於 27-10-2011 11:07 AM
Here is the fix on the Blue Knight Berserga
take the broken joint apart and extract the inner part from the forearm, cut the upper part that form the swing joint and sand it to a flat surface, reinsert it into the forearm (now the forearm has a dent in the place of the joint).
cut 2 pieces of plastic plate and drill a hole on each to make the base that hold the pc joint(left over from Gundam Model). the pc joint have to be trim on both sides to fit into the dent.of the forearm.
cut another piece of plastic (can be a spruce from model kit ) and glue it between the bottom of the two base piece and glue it into the dent of the forearm.
cut the joint from the upper arm and left only the round shaft. drill a hole and insert the forearm with pc joint. If the hole is too wide, coat the inside of the hole with super glue and wait till dry.
for the knee as the shaft broken so I replace them with pc spruce that have a metal pin inserted. then drill two hole on the side to hold the metal pin.
樓主: Douglas.M.Saint
[複製鏈接]
發表於 27-10-2011 00:52:10
